Removing Solar Panels to Replace a Roof in Sheffield: Costs, Sequence and Who Does What

Re-roofing guide | Sheffield & South Yorkshire

Quick answer

Removing solar panels to replace a roof in Sheffield typically adds from around £700 to £1,400 to the job for a standard domestic array, covering removal, safe storage and refitting. The panels come off before the tiles do, and the electrical disconnection and reconnection must be done by a qualified installer, not the roofing crew.

If you have solar panels and a roof that is coming to the end of its life, the awkward question is not whether the panels can come off. It is who touches what, and in which order. Get that wrong and you end up paying for two scaffolds.

It helps to know why the panels are treated as a structural item rather than an accessory. The Planning Portal is clear that building regulations normally apply to roof-mounted solar: the ability of the existing roof to carry the load of the panel has to be checked and proven, and some strengthening work may be needed. That check does not disappear because the array was on the old roof — it applies again to the new one.

Why the panels have to come off

A domestic array is fixed to roof hooks that bolt through the covering into the rafters. Those hooks sit under the tiles. You cannot strip a roof around them, and you cannot re-lay a roof underneath them, so on any full replacement the array comes off first and goes back on last.

There is one genuine exception. If the work is a localised repair — a slipped tile at the eaves, a ridge re-bed, a valley on the opposite slope — the panels usually stay exactly where they are. The rule of thumb we use is simple: if the underlay or the battens under the array are being touched, the array is coming off.

The mounting hardware itself is the part that most often needs replacing rather than reusing. Roof hooks that have been weathering for a decade, and the flashing kits around them, are cheap compared with the labour of getting back up there. Panels and rails are usually fine.

Solar panel array mounted on a pitched tiled house roof before a roof replacement

Who does what: roofer, installer, or both

This is the part that gets muddled, so to be plain about it: the roofing crew handles the roof, and a qualified electrical installer handles anything carrying current.

Isolating the array, disconnecting the DC strings, and later reconnecting and re-commissioning it are electrical works. Building regulations cover the electrical side of a solar installation, which is why the Planning Portal points homeowners towards an installer registered with a Competent Person Scheme. That registration is what allows the work to be self-certified rather than notified separately to building control.

In practice the split looks like this.

  • Solar installer: isolates and disconnects the array, removes the panels and rails, stores or hands over the panels, then refits, reconnects and re-commissions.
  • Roofer: strips the covering, replaces battens and underlay, re-lays the tiles or slates, and forms the weathering details around the new roof hook positions.
  • Both, together: agree the hook positions before the tiles go back on. This is the single conversation that prevents a leak later.

Some roofing firms offer to lift panels themselves. Mechanically they often can. The problem is that the moment the array is disconnected and reconnected by anyone outside a recognised scheme, you may have no certificate for the work and a manufacturer or installer warranty that no longer stands up.

What removal and refitting costs

These are indicative from-figures based on our own recent Sheffield projects and the installer costs our customers have been quoted. They are not quotations.

Item Typical from-price Notes
Removal of a domestic array (up to about 12 panels) from £350 Isolation, disconnection, panels and rails down
Refit and re-commission from £400 New hooks and flashings, reconnection, testing
New roof hooks and flashing kits from £150 Rarely worth reusing ten-year-old hardware
Safe storage during the works from £0 Often free if the panels stay on site and covered
Larger arrays (16 panels and up) from £1,200 total Two-slope arrays and optimisers cost more

Scaffold is the cost worth protecting. It is already in the roofing quote, and if the same scaffold serves the panel removal and the refit, you pay for it once. Sequenced badly, you pay for it twice — and on a Sheffield terrace with a highway licence, that is not a small number.

Roofer working on a stripped pitched roof during a re-roofing project in Sheffield

The sequence that keeps the cost down

The order below is the one we ask customers to book, and it exists to keep the scaffold count at one.

  • Roof survey first. Confirm the roof genuinely needs replacing before anyone books an installer. Sometimes it does not.
  • Book both trades against the same scaffold dates. The installer needs a half day at the start and a half day near the end.
  • Scaffold up, panels off. Panels and rails come down and are stored flat and covered, ideally in a garage rather than outdoors.
  • Roof replaced. New underlay, battens and covering, with hook positions agreed before the last courses go on.
  • Panels refitted, tested, scaffold down. Ask for the commissioning paperwork before the scaffold leaves, not after.

If you want a fuller picture of what the roofing half of that programme involves, our Sheffield re-roofing guide walks through the strip, the timber checks and the reinstatement in detail.

Regulations, warranties and the paperwork

Three things are worth confirming in writing before work starts.

Planning. Domestic solar is usually permitted development, but the Planning Portal notes that this only holds where important limits and conditions are met. If the panels are going back in a different position or projecting further from the new roof plane, check the position rather than assume it carries over.

Structure. The load check applies to the new roof. In most cases a re-roof uses the same rafters and the answer is unchanged, but if timbers are being replaced or the covering is changing to something heavier, that assumption needs testing rather than repeating.

Warranties. Two run in parallel: the roof and the array. Ask your installer in writing whether removal and refit preserves the panel and workmanship warranty, and who certifies the electrical reconnection. Before any of that matters, though, the roof itself needs assessing properly — our guide to what a Sheffield roof inspection includes explains what a survey should cover.

What most homeowners get wrong

The common error is treating the panels as the main event. They are not. The roof underneath them is, and the array is simply an access problem to be sequenced.

The second error is the more expensive one: replacing a roof while the panels stay on, because someone offered to work around them. It cannot be done properly. The underlay and battens under the array are the part of the roof most likely to be doing the actual leaking, precisely because they have been shaded, penetrated by hooks and left undisturbed for years. Leaving that section untouched means you have paid for most of a new roof and kept the oldest part of the old one. If you are unsure what condition that hidden layer is in, our guide to the signs roofing underlay is failing covers what to look for.

The third is booking the trades separately, weeks apart, and paying for scaffold twice.

Where the roof is genuinely at the end of its life, the work itself is standard — you can see how we specify it on our full roof replacement page, or for pitched work generally on our new pitched roofs page.

Solar panels and a roof that needs replacing?
Call AJR Roofing on 07852 940350. We will survey the roof, tell you honestly whether it needs doing, and coordinate dates with your solar installer so the scaffold only goes up once.

Contact us today

Frequently Asked Questions

Do solar panels have to be removed to replace a roof?

For a full replacement, yes. The mounting hooks pass through the covering into the rafters, so the tiles, battens and underlay underneath cannot be renewed with the array in place. For localised repairs away from the array, the panels normally stay put.

How much does it cost to remove and refit solar panels in Sheffield?

As an indicative range, from around £700 to £1,400 in total for a standard domestic array, covering removal, new roof hooks and flashings, refitting and re-commissioning. Larger arrays and installations spread across two slopes cost more. These are from-figures, not quotations.

Can a roofer take the solar panels off?

A roofer can handle the mechanical side, but the electrical isolation, disconnection and reconnection should be carried out by a qualified solar installer — ideally one registered with a Competent Person Scheme, so the work can be certified and your warranty stands.

Will removing the panels void my solar warranty?

It depends on the wording and on who does the work. Removal and refit by a competent registered installer usually preserves both the panel and workmanship warranties. Removal by an unregistered party frequently does not. Ask the question in writing before the scaffold goes up.

Can the panels go back in the same position?

Usually yes, and it is normally the sensible choice because the roof is being detailed around them anyway. New hooks and flashing kits should be used rather than the originals, and the positions should be agreed with the roofer before the final courses of tiles are laid.

How long does the whole job take?

The panel removal is typically a half day and the refit another half day. The roof replacement in between is the long part — commonly five to ten working days on a standard Sheffield semi, depending on size, access and weather.

Reviewed and signed off by AJR Roofing— working roofers covering Sheffield, Rotherham, Barnsley, Doncaster, Chesterfield and the surrounding area. Prices are indicative from-figures based on our own recent work and are not a quotation. Electrical work on a solar installation should always be carried out and certified by a qualified installer.
Published 10 November 2026 · Last updated 10 November 2026